1-channel analogue input
Strain gauge
µCAN.1.sg-BOX
The µCAN.1.sg-BOX is a decentralized CAN module for the acquisition of strain gauge or resistance bridge signals. The CAN interface supports the protocol CANopen.
µCAN.1.sg-BOX: acquisition of forces, torques, sequences and voltages
Features
- Strain gauge full bridge
- Voltage 0…100 mV
- Supply voltage 5.0 V
- Accuracy 0.1 % (FS)
- Resolution 16-bit (1 µV)
- Sampling rate 20 ms / 50 Hz
- Galvanically isolated fieldbus
- Electronics protected up to 40 G (option)
- Vibration resistant up to 4.5 Grms (option)
- Fieldbus CAN
- Protocol CANopen / Raw CAN
Further designs
µCAN.1.sg-SNAP
1-channel analogue input strain gauge
µCAN.4.sg-BOX
4-channel analogue input strain gauge
µCAN.4.sg-F1
4-channel analogue input strain gauge
µCAN.1.sg-TRS
1-channel analogue input strain gauge
µCAN.1.sg-SENSOR
1-channel analogue input strain gauge
µCAN.1.sg-SNAP
1-channel analogue input strain gauge
µCAN.4.sg-BOX
4-channel analogue input strain gauge
µCAN.4.sg-F1
4-channel analogue input strain gauge
µCAN.1.sg-TRS
1-channel analogue input strain gauge
µCAN.1.sg-SENSOR
1-channel analogue input strain gauge
Ordering information
1-channel strain gauge acquisition module with CANopen, 5 V DC sensor supply, full brigdes ≥ 350 Ohm, designed for metric cable connectors. Signal wiring via screw terminals.
1-channel strain gauge acquisition module with CANopen, 10 V DC sensor supply, full brigdes ≥ 1kOhm, designed for metric cable connectors. Signal wiring via screw terminals.
Downloads
Datasheet µCAN.1.sg-BOX
1-channel analogue input strain gauge
PDF [250 KB]
Manual µCAN.1.sg-BOX
1-channel analogue input strain gauge
PDF [0 .9 MB]
Order a sample module
Get a
sample module!
Any questions?
+49 2241 – 25 65 9 – 0
Write an email or call us.